Butt Fusion

Visiting our FAQ to learn more about Polyware.

Category > Butt Fusion

01
Does the fusion bead affect flow?
No. The Hazen Williams C factor of 155 was determined with pipe that was fused together and thus contained inner fusion beads.
02
What type of butt fusion and its min. requirement shall be used for butt fusion connection?
  1. The butt fusion machine used shall certified to ISO12176-1by a recognized certification body (e.g: SIRIM, DVT, Wrc).
  2. A valid service and calibration record (min. once/ year)
  3. Capable of performing the task it is designed for, i.e. machine sizes against pipe size, correct jointing parameters must be programmed etc.
  4. Equipment should allow a printout of weld parameters and joint history for traceability.
03
What qualification needed for a butt fusion welder?
  1. Welders must hold appropriate certificates recognised by the relevant Water Authority or training party. This is evidence that appropriate training has been carried out, and they are capable of welding correctly.
04
What other equipment shall be used during butt fusion joint at site?
Recommended minimum mandatory ancillary equipment are required to ensure a quality butt fusion connection.
  • Shelters.
  • Pipe support rollers.
  • Indelible marker pens.
  • Ground sheets or base boards.
  • Clean cloths to wipe the pipes before trimming.
  • Spirit Level to ensure machine is level.
  • Bead size measurement tool.
05
How to determine the quality of butt fusion joint?
The following requirement shall be meet for a quality joint.
  • Bead Appearance.
  • No dirt contamination.
  • The gap.
  • Displacement.
  • Bead Width.


PRODUCT SERIES

Polyfuse

A High Quality PE pipeline system which able to sustain high pressure with low maintenance cost

Penguin Master

ISO Standard Mechanical Jointing System suitable for pipe PE 80 & PE 100

Penguin Smart

Advance Mechanical Jointing System with improved Quality, Design and Performance

HÜrner

Appointed by Germany Hürner (Plastic Welding Technology Company) as the technical support center for South East Asean Market

Read More
CONNECT WITH US
  • Headquarter Office Address
           Polyware Sdn. Bhd
           7, Jalan Zarib 1, Zarib Industrial Park, 31500
            Ipoh, Perak. Malaysia.
  • Marketing Office Address
           Polyware Solutions Sdn. Bhd. (NCC)
           (Non-Revenue Water Collaboration Centre)
           1, Jalan 6/2A, Seksyen 6, Bandar Rinching
           Industrial Park,
           43500 Semenyih, Selangor, Malaysia
  • +605 323 2788
  • +605 323 9236 | 322 9237

Switch to Mobile Version
Subscribe Newsletter