Compression Fittings

Visiting our FAQ to learn more about Polyware.

Category > Compression Fittings

When pressurized the assembled fitting, water leaks from the connection joint?
  1. Ensure the PE pipe used compliance to standard ISO4427/DIN8074/MS1058/EN12201 in term of dimensional specification. Refer to the attached PE pipe dimension table.
  2. Ensure the pipe end cut with even and flat surface.
  3. Ensure the pipe insertion reach the inner stopper of the fitting body.
  4. Fully tighten the locking nut with hand and with the help of strap wrench



A High Quality PE pipeline system which able to sustain high pressure with low maintenance cost

Penguin Master

ISO Standard Mechanical Jointing System suitable for pipe PE 80 & PE 100

Penguin Smart

Advance Mechanical Jointing System with improved Quality, Design and Performance


Appointed by Germany Hürner (Plastic Welding Technology Company) as the technical support center for South East Asean Market

Read More
  • Headquarter Office Address
           Polyware Sdn. Bhd
           7, Jalan Zarib 1, Zarib Industrial Park, 31500
            Ipoh, Perak. Malaysia.
  • Marketing Office Address
           Polyware Solutions Sdn. Bhd. (NCC)
           (Non-Revenue Water Collaboration Centre)
           1, Jalan 6/2A, Seksyen 6, Bandar Rinching
           Industrial Park,
           43500 Semenyih, Selangor, Malaysia
  • +605 323 2788
  • +605 323 9236 | 322 9237

Switch to Mobile Version
Subscribe Newsletter